What exactly is the difference between a surge protector and a fuse? Can a fuse protect the electronic devices from lightning instead of surge protector?
08.06.2025 09:50

There are three different concepts here that are getting confused.
A circuit breaker is similar, but is resettable.
This one hit behind the barn.
the problem then depends on "how fast does the fuse operate?".
He then describes Rainy Season and Lightning.
Lightning arrestor is a spark-gap device, and can be installed anywhere. What is important, is that the wire is thick enough to withstand the lightning bolt and conduct the energy away from the building.
Patriots OTAs takeaways: Drake Maye rises, Stefon Diggs returns, rookie WR shines - Boston Herald
He then asserts :
but this device (an Inductor) … impedes the rapid changes in the current.
Is the question then , "why buy a surge supressor, if the fuse alone protects the electronic circuits from a lightning bolt?".
Did Trump show us once again that he is a master debater?
An AC voltage/ current source, and an ac inductive load.
This device then solves the entire problem.
What does a fuse do?
Utah health officials monitoring potential measles exposure in southwestern Utah - KSL.com
(There is no concept of polarity, in the loop because the current changes direction 100 to 120 times a second (power frequency).
so, what happens?
These are simplified answers to the original question, and does not change anything I wrote above.
2024–09–27 [ Mohan Rajaratnam Mohan Rajaratnam ] . Thinks you can get free electricity from nothing : Mohan Rajaratnam's answer to Is it possible to generate free electricity at home using a magnet or other low-cost methods? If so, how does it work?
“ A surge suppressor is the one which is connected at the input supply so that when there is a sudden change voltage it bypasses thereby protecting the (circuit) and electronic components”
[image of Common-mode choke]
But during the surge, the fuse will not blow if it is a longer duration and lower value )10 to 50%).
Would individual surge supressors have save this equipment? most likely, since the surge supressor would take the jolt instead of the electronic components.
what exactly is a ‘surge’ protector?
Why do some men love sucking cocks?
eight
In schematic diagrams this is the symbol for a fuse:
Because the load is inductive, the current lags the voltage.(by a bit).
Observations of recently detected SN 2024aecx suggest it's a Type IIb supernova - Phys.org
At one ohm, the resistor has a maximum of 1 watt power.
But it can get overloaded, and no longer works.
Edit 2024–10.
The MOV will conduct when the voltage exceeds 50% of line voltage.
Here is a simplified AC power diagram.
This is the picture of an electronic coil of wire wound around a core of magnetic material.
Have you ever answered your door in lingerie?
2024–10–16 [ OO OLAOYE OYEBODE ]
For this case there are devices called Metal oxide varistors (MOV).
a photo is worth a thousand words.
This is where this question deviates from being a 'generic' question, and becomes more specific.
2024–10–11 [Victor Olarewsju Victor Olarewaju ]
This is a high voltage low current spike that comes down the line because of the power poles being struck, and the voltage suppressors activating on the primary side of the transformer.
One
And this is the problem alone. Is the power supply in the equipmemt designed with a lightning strike in mind? Some yes, others, no.
First Sentence:
One is “what exactly is in a ‘surge protector’ ? ”
“ A fuse is a device which protects the (circuit) against overload and short circuit.”
Mohan forgets that a fuse is a one-time device, and needs to be replaced if it is tripped.
I post the exact comment here.
Barnstars:
Now when you have a certain ac resistance, then a current flows in a loop.
but I think this circuit , shows a few more pieces.
It’s been three xxx five werks, and there has been no response to my follow on query on his Commment to my answer.
2024–10–14 [Omar Gharbi Omar Gharbi ]
So combined with a device called a MOV or Metal-oxide-resistor, then forms the 3rd part of a “surge suppressor “.
If the nominal power is 4,000 watts then the current at 230volts is 16 amps.
Upvotes:
When the current is 200% of the rated value , it will “go open” (the link metal melts) and protect the device.
2024–10–10[John johnson John Johnson ]
nine
It seems Mohan does not understand the difference between a comment and an Answer.
Once the voltage goes over 0.0650 volts, then this fact can be used to amplify the difference, and turn the circuit breaker off , furthur down the line. Essentially that is what a RCD/GFCI does, it compares the incoming current, to the outgoing current, and if the difference between the two currents is over 5mA, then it trips the circuit breaker.
There is no harm in having the surge suppressor along with the fuse in the circuit. The fuse will not open up until the current melts the link. This will take time, and in the interim, that jolt will get transmitted into the power supplies.
(Dc diagram shown, AC is similar).
But… the neutral is now “floating” because of the 1 ohm resistance.
The bolt then partially travels down the line to your home.
What is lightning?
OK, this is Mohan Rajaratnam’s definition of a Surge suppressor.
Can the fuse protect the electronic devices from lightning instead of a surge protector.
“ … to protect building, lightning arrestor, is provided above building and directly connected to earth.”
A fuse is a non-resetable over current circuit protector.
Fuses, on their own, then operate much slower than the MOV variable resistance, during the lightning strike.
These devices are installed between the “hot” and “neutral” and protective ground.
He then describes the function of a fuse.
The other is “what does a “fuse” do?”
2024–10–00 [ Ammar Mahdi ] Ammar Mahdi
So, it’s possible that these devices from Trip Lite have addition suppression devices, these ones seem to be sturdy.
This is 'the assistant's answer'
so, the loop of wire then, when put together with another loop reduces the ‘noise’ on a power line.
So, the voltage could go up to 500 volts, and the fuse will not open up.
It also is a device that limits the change in current flow.
At least they know the answer if they wanted it.
At the secondary, it is 1000 times less.)turns ratio). If it gets hit with a 100,000 volt bolt of lightning then the voltage arrestors conduct and clamp the voltage down to line voltage, ( but a small amount leaks down the line). This is the problem.
This is where the MOV conducts again, and dissipated the energy.
This is an electronic circuit designed to clamp voltages so that the Voltage Potential that appears at the outlet is never going to exceed the nominal value.
[old diagram got deleted by accident]
P = e* I, so since I is 16 amps, then the voltage dropped is 1/16 volt or 0.0650 volts.
There are two important concepts here.
The third is lightning and “how it gets conducted into a home.”
2024–10–11 [Bobby Sanchez Bobby Sanchez ].
This is a photo where a lightning bolt took out a home's complete mains distribution box, and a lot of electronic gear as well.